Passive fire stopping is the part of a building’s fire protection that most people never see, because it sits inside walls, floors and ceilings. It seals the gaps where pipes, cables and ducts pass through fire-rated construction, so a fire in one area can’t use those gaps to reach the next. This guide explains what it is, where it’s needed, what goes wrong, and how to check that yours is doing its job.
What Is Passive Fire Stopping?
Passive fire stopping (also called firestopping or penetration sealing) closes the openings in fire-rated walls, floors and ceilings that are left when services are run through them. Every cable, pipe, duct or conduit that passes through a fire-rated element leaves a gap. Left open, that gap can let flames, hot gases and smoke into the next compartment, and it can undo the fire rating of the whole wall or floor.
It is one part of
passive fire protection, which also covers fire doors, fire-rated walls and floors, and fire-rated hardware. Fire stopping is the part that deals with the holes and joints.
Where Fire Stopping Is Needed
- Service penetrations: pipes, cables, conduits and ducts passing through fire-rated walls and floors.
- Service risers and plant rooms: vertical shafts and plant spaces where many services pass through at once. See our guide to fire stopping in plant rooms and vertical risers.
- Joints: the gap between a fire-rated wall and the floor or ceiling above it, and expansion or control joints.
- Around fire doors and frames: gaps between a frame and the wall around it. See steel door frames.
Common Fire Stopping Materials
The right product depends on the service, the size of the gap and the wall or floor it passes through:
- Fire-resistant sealants and mastics: for small gaps around cables and pipes.
- Intumescent collars and wraps: fitted around plastic pipes. They expand under heat to close the pipe as it softens.
- Fire-rated putty pads and sealing systems: used around electrical boxes and similar fittings.
- Fire-rated boards, batts and mortars: for larger openings.
Products are not interchangeable. A fire stopping system is tested as a combination of the product, the service and the wall or floor, so the one you use needs to match the tested system for that situation.
Why Fire Stopping Fails
Most failures happen after the original installation, not at handover:
- Later trades. Electricians, plumbers and data installers drill new holes or pull cables through existing seals, and the opening is not resealed.
- Wrong product for the service. A sealant used where a collar was needed, or a product that was never tested for that wall type.
- Gaps left unsealed. Small openings behind panels, above ceilings or in risers that nobody inspects.
- No records. Without documentation of what was installed and where, it is hard to show a penetration has been sealed properly.
This is why fire stopping needs checking whenever building work disturbs a fire-rated element, not only at construction.
How to Check Your Building’s Fire Stopping
- Walk the fire-rated elements. Check plant rooms, risers, ceiling voids and the edges of fire-rated walls for visible gaps or unsealed penetrations.
- Look for recent work. New cabling, pipework or equipment in a fire-rated area is a prompt to check the seals around it.
- Ask for the paperwork. Installation records and test or system details help show that the right product was used.
- Get it assessed. If you’re not sure, have a qualified contractor inspect and fix anything that doesn’t look right.
How CFS Can Help
Comprehensive Fire Services (CFS) installs and repairs
passive fire stopping in strata, commercial and industrial buildings across Sydney. We also supply, install and inspect fire doors, so a building’s fire compartments can be dealt with in one visit. See our
testing and inspections service for the doors, or contact us about your fire stopping.
Call Now → 0418 749 488
Contact Us → https://www.firedoorspecialists.com.au/contact-us/